sdik-hpa-for-spring-sniper-riflesHP buttstock for Ares Amoeba Striker
main-categoryMancraft Mjolnir Amplifier
Please choose right fitting size for your conv. kit on the list below. 4mm for SDiK, 6mm for PDiK.
100% secure payment
Simply and cheap regulator?
Something that will allow you tu have bit higher pressure?
It's the device for reducing the pressure of the gas. Pressure can be adjusted in the range of from 0 to about 15bar. Adjustment is done by the knob at the top of the regulator. By turning clockwise - the pressure increases.
Output of the regulator adapted to fi 4mm hose (used in SDiK conversion kits) or 6mm (for PDiK)
Thread at the output is standard airsoft thread so: you can simply put QD in here. Unscrew our fitting and screw in fitting for your HPA line.
Entrance of regulator - thread G1/2 "- Standard Paintball CO2/HP bottles and 12g CO2 adaptors.
The regulator can be used with ON / OFF and the PIN bottles.
To use it with HP tank you should put m4 screw (in set) in bottom of the regulator. It will press pin in HP tank. That screw should be out for 1-2mm.
Type of gas: CO2/HP.
Manometer shows output pressure.
Output of the hose - angular L-shaped
Sold with the safety valve.
Along with the regulator comes additional spring. Exchange: http://shop-mancraft.com/en/content/32-regulator-spring-exchange
- Lifetime guarantee